Preparation method for supported metal catalysts using w/o microemulsion: Study on immobilization conditions of metal particles by hydrolysis of alkoxide

It was previously found that the silica-supported rhodium catalyst prepared using water-in-oil microemulsion had rhodium particles partly, or wholly, embedded in silica. In this work, consequently, we investigated the effect of hydrolysis conditions of tetraethylorthosilicate, employed as the source of silica, on the atomic ratio of surface rhodium in contact with the gas phase, to total surface rhodium of nanoparticles. This ratio is denoted as R in this paper. R became higher when the catalyst was prepared under the following hydrolysis conditions: a shorter hydrolysis time and a smaller amount of tetraethylorthosilicate. On the other hand, R showed the minimum value when the water content in the preparation solution was 33 vol%. From these results, it is demonstrated that it was important to form silica as early as possible in hydrolysis of TEOS in order to increase R values. In addition, the effect of R on the catalytic behavior in CO hydrogenation was investigated. At R values below 30%, the turnover frequencies increased with a decrease in R.     

Factors Influencing the Adhesion of Microorganisms to Surfaces

Starvation, growth phase, and carbon source influenced bacterial cell surface hydrophobicity. Both the number and kind of microorganisms that colonized metal surfaces depended on the type of metal and the presence of an imposed electrical potential. No significant differences in attachment and growth of a pure culture were observed when metal surfaces were dipped in an exogenous energy source. The chemical composition of naturally occurring adsorbed organic films on metal surfaces was shown to be independent of surface composition and polarization.     

A Posture Control Model and Balance Test for the Prediction of Relative Postural Stability

A balance testing methodology has been developed based on a posture control model which defines relative stability by the degree to which a transient postural perturbation causes the center-of-pressure on the feet to approach the limits of the base-of-support. To minimize anticipatory adaptations and to ensure subject safety, the balance test uses a small-amplitude continuous random or pseudo-random perturbation. The data are used to identify an input-output model, which is then used to predict large-amplitude transient response. Sixtyfour normal subjects were tested, as well as five patients with vestibular lesions and five elderly subjects with a history of falling. Tests were performed with eyes open (EO) and blindfolded (BF), and the EO/BF ratio was calculated. The results showed highly significant differences between young (20-40) and elderly (61-79) normals, but no differences between males and females. In using the balance test to identify the balance-impaired individuals, the BF and EO/BF data provided higher success rates than the EO data. Depending on the modeling method used, the balance test was able to identify up to three of five vestibular patients and five of five elderly fallers, at a false positive rate of 25 percent in the normal subjects.     

Effects of level of processing and rehearsal on frequency judgments.

Studied the effects of attention during encoding and rehearsal after initial encoding on frequency estimates in 3 experiments. Exp I found that varying the level of processing affected the linear increase in frequency estimates as a function of actual frequency, but varying processing after encoding with remember or forget cues had the greatest effects on the intercept of the function relating judged to actual frequency. Deeper levels of processing improved performance in a frequency discrimination task, whereas remember and forget cues had small effects on performance. In Exp II, materials that are easy to rehearse were compared with materials that are difficult to rehearse. Results were interpreted as evidence against a covert rehearsal explanation of slope effects in frequency estimation tasks because materials that are difficult to rehearse produced larger interactions between remember vs forget cues and frequency than materials that are easier to rehearse. In Exp III, an arithmetic task that was performed during word encoding affected the slope of the function relating judged to actual frequency, but the same task performed immediately after word presentation had no effect on frequency estimates. It is concluded that frequency is not stored automatically because attention during the initial stages of encoding affects it; however, attention devoted to processing after initial encoding does not affect the rate with which subjective frequency increases with repetitions. (22 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Enhancement of low density lipoprotein binding to both low density lipoprotein receptor-positive and- negative cells by tetracycline antibiotics

Some tetracycline (TC) antibiotics, including TC and anhydrotetracycline, have been found to enhance specific binding of low density lipoprotein (LDL) to both LDL receptor-positive and-negative cells at relatively higher concentrations. When incubated at 37°C, the ability of LDL receptor-negative human fibroblasts to bind ¹²⁵I-LDL was increased from<2 to 45 ng/mg by 170 μM TC. In normal human fibroblasts and Hep G2 cells, ¹²⁵I-LDL binding was elevated 1.4- to 2-fold by 113 μM TC. The ¹²⁵I-LDL binding in the presence of TC was diminished by both heparin and EDTA. The enhancement by TC was not observed when ¹²⁵I-LDL binding was assayed at 4°C. TC enhanced LDL binding to paraformaldehyde-fixed Hep G2 cells, excluding LDL receptor induction in the mechanism. These results demonstrated that TC enhanced cellular LDL binding through a process not involving functional LDL receptors.     

Naming and locating the tops of rotated pictures.

Investigated whether and how pictures are mentally rotated to upright before they can be named. Four experiments were conducted with 12 college students in each, who were given the tasks of naming pictures of common objects with various orientations and locating their tops. In the naming task, Ss required more time the farther the picture was from upright, but the rotation effect was reduced after Ss had named each picture once, indicating that rotation may be required only for unfamiliar stimuli. The top locating task was faster with upright figures, but otherwise-oriented pictures required the same time regardless of orientation. Top-locating was faster than naming, indicating that "topness" may be guessed even in unfamiliar figures, while naming also involves searching one's semantic memory for a name. (French abstract) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Experimental evidence on molecular interaction in desorption and adsorption of CO molecules on metal surfaces

Adsorption and desorption of CO on Ni(100) and Pt(111) surfaces are presented. At the thermodynamic equilibrium, the site occupation between the terminal and the bridged sites are described with the free energy of the system, including the vibrational entropy. Adsorption of CO onto a cold surface as 20 K has also been studied by infrared reflection absorption spectroscopy (IRAS). The occupation ratio of bridged CO to terminal CO species on Ni(100) at 20 K ranges from ～ 2·8 to 0·7 at the total coverage from 0·003 to 0·15 ML. Such strong coverage dependence of the occupation ratio even at small coverages suggests that the interaction between CO molecules operates at relatively long range (> 10 Å). The isotope experiments suggest that there is substantial interaction between preadsorbed (accommodated) CO species and incoming (mobile) CO species. Desorption process is also affected by the interaction between the adsorbed CO and the incoming species. The effect of temporal bimolecular CO interaction on the desorption kinetics is also discussed.     

Measurements of thermal conductivity and thermal diffusivity of alternative refrigerants in liquid phase with a transient short‐hot‐wire method

A transient short‐hot‐wire method has been proposed to simultaneously measure the thermal conductivity and thermal diffusivity of liquids. The method has been applied to the refrigerant HCFC‐22, alternative refrigerants HFC‐32, HFC‐125, HFC‐134a and refrigerant mixtures HFC‐32/125 [35/65, 50/50 (HFC‐410A), 68/32 wt%], HFC‐32/125/134a [23/25/52 (HFC‐407C) wt%]. From the present study, it is shown that the measured results agree well with the literature values on thermal conductivity and those on thermal diffusivity obtained from NIST's thermophysical property database, REFPROP Ver. 6.0. © 2004 Wiley Periodicals, Inc. Heat Trans Asian Res, 33(8): 540–552, 2004; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20032